Digicom 3G Gateway HSUPA 2M Guia de Instalação descarregar pdf (Página 11)

Digi TransPort

WR11 Installation Guide

Page 11

Digi TransPort WR11 Provisioning

CDMA provisioning is different from GSM since CDMA (in most cases) does not use a SIM card. The CDMA

module provisioning process creates a CDMA data connection to the mobile carrier network. This authenticates

the modem and retrieves account information which is written to ash memory on the CDMA module itself, not

the Digi’s conguration le. Mobile account information is stored on the CDMA module. Therefore, you cannot

remove provisioning information from the CDMA module by performing a factory reset on the TransPort WR11

device.

If provisioning fails (the device does not obtain a phone number), contact the carrier and verify that the device

has an active account. You will need to provide the MEID of the device which is available under Management

- Network Status > Interfaces > Mobile.

The status of a successfully provisioned CDMA module is shown in the following image. Note that the device

has obtained a phone number.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

Sem comentários

Digicom 3G Gateway HSUPA 2M Guia de Instalação Página 11